Otto Bock Dino 3, Инструкция по эксплуатации

Страница: 8 / 32

CAUTION
Failure to verify readiness for use before putting into operation
Tipping, falling due to incorrect adjustment or installation
► Check the existing settings prior to first use.
►
After each assembly, verify the proper fit of the removable wheels. The quick-release axles must be firmly
locked in the quick-release axle housings.
► In particular, verify tip resistance, easy operation of the wheels and correct brake functionality.
CAUTION
Loss of stability
Tipping, falling due to additional objects on the product
► Do not attach additional objects to the frame, cross tubes or seat.
CAUTION
Incorrect air pressure
Uncontrolled driving characteristics, falling, tyre rupture due to incorrect inflation
► Maintain sufficient air pressure in pneumatic tyres. Do not exceed the permitted specifications when filling the
tyres (see Page 27).
►
Do not use the product with over/under-inflated or unequally inflated tyres.
► Note that a single tyre with low air pressure can lead to uncontrolled driving characteristics.
►
Note that low pressure of the rear wheels / drive wheels can reduce the braking force of the knee lever wheel
lock.
INFORMATION
Only metric screws are generally used on the product.
INFORMATION
With screw connections consisting of an Allen head screw and hexagon nut, a higher torque can be transmitted
using the hexagon nut than the Allen head screw.
Tighten and loosen the screw connection on the hexagon nut, using the Allen head to secure the screw against
turning.
1) For plug-on drive wheels: Attach the drive wheels to the drive wheel attachment device. The quick-release axles
must not be removable after releasing the push-button.
2)
Optional:
Slide the leg supports into the holders on the front frame tube.
3)
Optional:
Fold down the foot plates. If necessary, engage and readjust the calf strap.
4) Prior to the adaptation of the seating shell/seating solution, further settings on the mobility base for seating
shells must be adjusted as required (see Page 11 ff.).
5) If necessary: Adapt the seating shell/seating solution to the mobility base for seating shells (see Page 8).
6) Verify the stability of the assembled product.
INFORMATION: Inform the user and the attendants if the static stability is found to be less than 10°. In
this case, determine additional safety measures together with the user and attendants to ensure the
safety of the user.
6 Installing options/accessories
WARNING
Using alternative seating solutions
Serious injuries to the user due to missing anti-tipper
► If the product is fitted with an alternative seating solution or seating shells from other manufacturers, special
attention must be paid to static stability.
► The qualified personnel is obligated to ensure the static stability of such a combination.
► Using an anti-tipper may be required depending on the centre of gravity.
►
Verify that the anti-tipper has been installed and adjusted properly.
8
Installing options/accessories
Dino 3