Otto Bock Avantgarde XXL 2, Инструкция по эксплуатации

Страница: 25 / 32

--- = Combination not possible.
All information without seat cushion at 0° seat inclination.
The anterior seat height depends on the selected wheel size, caster fork and mounting position. Please refer to the
seat height table!
Seat inclination: 100 mm maximum seat height difference between front seat height and rear seat height (equalling
a seat inclination of about 15°).
Without indication of the desired seat inclination, it will be factory-set at approx. 4°.
Rear seat height [mm]
Drive wheel size/tyres Mounting position
(
see fig. 36
)
24" 26"
1 400 420
2 425 445
3 445 465
4 470 490
5 490 510
6 510 530
All information without seat cushion at 0° seat inclination.
The rear seat height depends on the selected wheel size, caster fork and mounting position. Please refer to the
seat height table!
Seat inclination: 100 mm maximum seat height difference between front seat height and rear seat height (equalling
a seat inclination of about 15°).
Important notice: The axle can be adjusted horizontally between the front and rear axle position in 7 dif­
ferent positions (A through G; see fig. 36). Position A allows a passive centre of gravity. The most active
centre of gravity is reached in position G. Unless otherwise specified, the drive wheel position will have
the standard setting of D/4.
35 36
Lower leg length [mm]
Measured from front edge of the seat upholstery to rear edge of the foot plate
(see fig. 37; lower leg length minus thickness of seat cushion used)
Foot plate bar, short (230 mm)
Specification for seat depth 380 mm
Foot plate bar, long (320 mm)
Specification for seat depth 420 mm
Min. Max. Min. Max.
XXL 2 320 460 390 550
--- = Combination not possible.
All specifications for narrow handrim installation (in case of wide installation: +20 mm).
25 Avantgarde XXL 2
Technical data