Otto Bock Avantgarde CLT, Руководство по обслуживанию

Страница: 30 / 64

91 92
3.10 Assembly E: Side Panels
3.10.1 Replacement work on "standard" and "clothing protector" side panel
3.10.1.1 Replacing the side panel
1) Remove the rear wheel.
2) At the back tube unscrew the size 5 Allen head screw from the side panel (see fig. 93).
3) Unscrew the mounting screw on the adjustment disc and remove the cover of the adjustment disc (see fig. 94).
4) Remove/replace the side panel.
93 94
Installing/adjusting the side panels
Fine adjustment of the side panels to the rear wheel position is required during installation:
1) If necessary, slightly loosen the slide block on the bottom of the frame (see fig. 95).
2) Connect the side panel mounting on the back tube to the side panel – do not tighten (see fig. 93).
3) Push on the rear wheel to determine the position.
4) Adjust the position:
→ Front: Find the position of the adjustment disc relative to the mounting point (see fig. 96).
→ Rear: Adjust the angle (see fig. 97).
→
Slide block: If necessary, adjust the depth position (see fig. 98, item 2).
5) Push the cover onto the adjustment disc (see fig. 98, item 1). The marks on the disc help to find the position.
6) Securely retighten all the screws.
7) Push on the rear wheel and ensure that it can rotate freely.
→ After adjustment of both side panels, both rear wheels must rotate freely without scraping noises.
30
Service Work
Avantgarde CV / CS / CLT