Otto Bock 490E75 1 C Series, Инструкция по эксплуатации

Страница: 17 / 128

6.3.1 Adjusting the control device
WARNING
Incorrect configuration settings
Falling, tipping over, collision due to programming errors
► Programming may only be performed by qualified personnel. The manufacturer of the product and the control
device manufacturer are not liable in case of damage caused by programming which was not performed prop­
erly and/or which was not adjusted properly according to the user’s abilities.
If necessary, the qualified personnel can adapt the preprogrammed wheelchair control unit and options to the con­
crete requirements of the user.
7 Use
7.1 Circuit breaker
INFORMATION
►
Should the fuse burn out repeatedly after a short time for no discernible reason, contact the qualified person­
nel.
► For shipping or when the power wheelchair is not being used for an extended period of time, the fuse should
be removed.
Before the power wheelchair can be switched on, the fuse must be inserted into the fuse holder provided for the
purpose. It is located at the front under the seat (see fig. 4).
Note:
The fuse typically comes installed in the dedicated fuse holder when the wheelchair is handed over to the
user.
4
Installing the fuse
1) Remove the fuse from the protective cover provided
on the control panel.
2) Flip open the cover of the fuse housing (see fig. 4,
item 1) and insert the fuse (see fig. 4, item 2).
Make sure that the fuse is pressed into the centre of
the spring contacts and that it is not positioned at
an angle.
3) Close the cover of the fuse housing.
Removing the fuse
>
Prerequisite:
The control device is switched off.
1) Flip open the cover of the fuse housing (see fig. 4,
item 1).
2) Pull the fuse out straight (see fig. 4, item 2).
3) Close the cover of the fuse housing.
7.2 Side panels
The side panels protect the user and his/her clothing from getting dirty.
The installed armrests offer the user additional support for the forearms.
7.2.1 Removing/installing the side panels
INFORMATION
► If elevating side panels are mounted on your product, they can be removed in the same manner as described
in this section.
►
Follow the instructions for elevating them in the next section.
To make getting in from the side easier or for transportation, the side panels can be removed if needed.
17 490E75=1_C
Use