Otto Bock 480S26 20000 K, Инструкция по эксплуатации

Страница: 16 / 40

7.4 Adjusting the caster wheels
With this wheelchair type, the caster wheel position and caster wheel journal angle cannot be adjusted.
7.4.1 Replacing the caster wheels
The caster wheels can be replaced in case of wear.
1) Loosen the caster wheel axle screw connection (see fig. 12, item 1).
2) Remove the caster wheel axle/spacers (see fig. 12, item 2).
3) Remove and replace the caster wheels.
4) Install the caster wheels together with the spacers. Tighten the caster wheel axle screw connection to
8 Nm .
11 12
7.5 Adjusting the back support upholstery / seat upholstery
7.5.1 Adjusting the back support upholstery
INFORMATION
A well-adjusted backrest provides lasting comfort for the wheelchair user and reduces the risk of secondary dam­
age and pressure zones. Do not create too much pressure.
INFORMATION
Ensure that the user's pelvis is positioned as far back in the wheelchair as possible, i.e. between the backrest
tubes.
The back upholstery is attached to the frame tubes with hook-and-loop straps.
1) Fold up the backrest padding.
2) Open and loosen the hook-and-loop straps one after the other (see fig. 13).
3) Sit and position the user in the wheelchair.
4) From the bottom to the top, adjust the tension of the hook-and-loop straps to the weight and anatomical condi­
tion of the user and fasten the straps (see fig. 14).
INFORMATION: The two ends of the hook-and-loop strap have to overlap by at least 100 mm in each
case.
INFORMATION: Adjust the respective lower hook-and-loop straps somewhat tighter.
INFORMATION: Deviating adjustments may be required in specific cases; this is the responsibility of
the attending therapist.
16
Settings and assembly instructions
Invader 480S26=20000_K