Otto Bock 17AD100 20, Инструкция по эксплуатации

Страница: 41 / 264

15) Insert the spring dummy (item 3) into the module (see fig. 31).
16) Place the spring bolt (item 2) on the module and fasten it with a Torx
wrench (see fig. 32). The spring dummy must fit in the module without
play.
17) Put the orthosis on the patient (see fig. 33).
See the illustration of the Reaction-module for the corresponding wrench
sizes and tightening torque values (see fig. 7).
Reaction module – static trial fitting
INFORMATION
The stop pin is equipped with a thread lock, which makes the stop pin hard
to turn during adjustment. Do not turn the stop pin any more than neces­
sary, since the thread lock is easily damaged and this can lead to prema­
ture wear and tear. Optionally the 17AD100A=MA* mounting adapter can
be used with the Torx wrench for additional leverage.
> Required materials: 743A8 knee pivot point gauge
> Prerequisite: The Reaction-module is mounted to the spring dummy in
the ankle joint.
1) Put the orthosis on the patient (see fig. 33).
2) Use the knee pivot point gauge to mark the compromise pivot point
according to Nietert on the knee joint (see fig. 34).
3) Guide the Torx wrench through the spring bolt (see fig. 35) and adjust
the stop pin (see fig. 7, item 10) to change the angle of the upper ankle
joint. Relieve the lower leg by hand so that the stop pin moves easily in
the thread (see fig. 36).
4) Readjust the stop pin if necessary so that the orthosis does not have any
play in the anterior/posterior direction.
5) Check the static alignment of the orthosis using the L.A.S.A.R. Posture
(see fig. 37).
Reaction module – dynamic trial fitting
>
Required materials:
17AD100A=HS-*-1 spring (strong) or
17AD100A=HS-*-2 spring (extra strong)
>
Prerequisite:
The Reaction-module is mounted to the spring dummy in
the orthotic ankle joint.
1) The spring dummy must be removed and replaced with the Reaction-
Spring prior to the dynamic trial fitting. Use a Torx wrench to loosen the
spring bolt (see fig. 7, item 2) and remove it from the module.
2) Remove the spring dummy (item 3) and replace it with the Reaction-
Spring (item 4) (see fig. 38).
41