OTT HydroMet SUTRON XLINK 100, Руководство по эксплуатации и техническому обслуживанию

Страница: 142 / 248

Page 142 of 248
Wifi
Enable Wifi
Always
On Result
OFF - The Wi-Fi hotspot is off. It is only turned on if the
wakeup button is pressed. It stays on for one hour
after the button press.
ON ON The Wi-Fi hotspot is always on.
ON OFF The Wi-Fi hotspot is turned on for 10 minutes:
•
at boot up
•
when the station is connected to, whether
via USB, over the modem, or over Wi-Fi
•
after an SMS is received
•
after a LISTEN command.
The Wi-Fi hotspot turns on for one hour when:
•
The wakeup button is pressed
•
The station goes into alarm
12.2 Log Daily Values
The station can log diagnostic information at 23:59:59 each day. That information consists of current
battery voltage, current temperature, and telemetry accounting, such as the number of transmissions
made and the number of bytes transmitted.
To prevent this data from being logged, disable the Log Daily Values setting. Even if logged, the data will
only be downloaded if the Include Events option is selected during the download.
12.3 Digital Output
XLink includes one digital output labeled DOUT 1.
The digital output is DOUT#1 (Output1). The digital output is an open collector type output. This provides
direct interface to many products. The open collector output sinks 100mA (rated at >400mA) on a
continuous basis.
It is expected that a pull-up resistor will be connected to the Prot+12V or other supply. The value of the
pull-up may be determined by the impedance of the connected load. A10 kOhm resistor may be used as a
default.
With a pull-up resistor connected

When the output is turned on , the output sinks current from all attached devices.