本体を組み立てよう
1.脚をつける。
2.回路を組み込む。
3.本体を組み立てる。
3.スピーカーを本体（後）に
つば付きネジでとめる。
3.本体（上）を本体（下）にはめて
ネジ（大）でつける。
2
Otona
no
Kagaku
The Structure of the
Theremin mini
The theremin is an electronic
instrument which makes sound by
drone of two frequencies.
speaker
switch lever
(This is used to
switch on and off
and to change
the sound level.
It cannot change
the volume while
playing.)
batteries (four size
AA batteries)
volume for tuning
(Used to adjust
two frequencies.)
antenna
circuit (This
makes two
frequencies.)
本体を組み立てよう
1.脚をつける。
2.回路を組み込む。
3.本体を組み立てる。
3.スピーカーを本体（後）に
つば付きネジでとめる。
3.本体（上）を本体（下）にはめて
ネジ（大）でつける。
本体を組み立てよう
1.脚をつける。
2.回路を組み込む。
3.本体を組み立てる。
3.スピーカーを本体（後）に
つば付きネジでとめる。
3.本体（上）を本体（下）にはめて
ネジ（大）でつける。
本体を組み立てよう
1.脚をつける。
2.回路を組み込む。
3.本体を組み立てる。
3.スピーカーを本体（後）に
つば付きネジでとめる。
3.本体（上）を本体（下）にはめて
ネジ（大）でつける。
Assembling the Body
Put legs into the lower body and
fix with small screws.
Attach the
legs.
1
Install the circuit board.
2
When you bring your hand close to the
antenna, you can play high sound and when
you bring your hand away, you can play low
sound. The sound changes continuously, not
stepwise.
How to magnetize the driver
a hand of the player
small screw
small
screw
small screw
lower body
leg
leg
leg
leg
A strong magnet is used in
the speaker. Rub the tip of
t h e d r i v e r a g a i n s t t h e
magnet at the back of the
speaker a couple of times to
the same direction, and the
t i p o f t h e d r i v e r i s
magnetized to stick the
screws. Let’s try!
driver
※ For easy handling, stick a
screw to the magnetized tip of
the driver.
small screw
small screw
small screw
small screw
※Take the
connector out
of this part.
lower body
connector
red
black
circuit board
1
.Set the circuit board into the
lower body and fix with small
screws.
※ Be careful of the wires of the
speaker since it comes off
easily. Use caution not to touch
the transparent cone since it is
dented easily.
※he wires of the
speaker come off
e a s i l y . P a y
attention not to
pull too much.
2
.Insert the connecter of the battery box into the circuit
board.
※Pay attention to the
direction and insert
completely.
※See the
figure carefully
and pay
attention to the
direction of the
circuit.
※ Screw the
legs after
putting into
the lower body
completely, or
the legs are
fastened
loosely and
cause rickety
legs.
Use caution
not to touch
the
transparent
cone part
since it is a
delicate part
to make
sounds by
vibration.
