IET8242MPpH-S-DR
Hardened Managed 8-port 10/100/1000Base-TX(PoE+) + 4 port 100/1000Base-FX SFP
Ethernet Switch
3
The switch is attached to DIN Rail
b)
Wall Mount Installation
(Optional)
1. Attach the wall mounting plates to rear panel of the chassis. Insert screws and tighten then with a
screwdriver to secure the plates.
Attaching Wall Mounting Plates to the Switch
2. Install user-supplied screws on the appropriate location on the wall.
3. Make sure that the switch is attached securely to wall.
5.
Start-up
a. Connect the Ethernet port of the Hardened Managed PoE Ethernet Switch to a PC or network device with a
network cable.
b. Insert the appropriate SFP module into the SFP port. Connect the fiber cable from the remote device to the LC
connector of the SFP of the Switch (near end).
c. After the devices are powered on, the PWR indicators will all be on. If the indicators are not on, check the
power supply connection.
d. After all cables are correctly connected, the indicators will be lit as per port status LEDs. Please refer to the
Operational Instructions for detail descriptions
