English - 6
USING YOUR STEAMER VERTICALLY
You can use your Steamer in the vertical position to press with steam hanging garments
and drapes.
Note: If your model incudes the Over the Door Press Pad, follow the instructions under
SETTING UP AND USING YOUR OVER THE DOOR PRESS PAD.
Caution: Heated press bar gets hot. Do not touch!
1. With the water tank filled, attach desired accessory to use on your garment (refer to
ATTACHING AND REMOVING ACCESSORIES).
2. Hang your garment to be steamed on a clean, rust-free hanger.
3. Plug unit into a standard electrical outlet.
Warning: Care should be taken to arrange the cord so that it cannot be pulled or
tripped over. Always make sure you can move freely without getting tangled with the
cord.
4. Slide the switch to Low or High. The red power indicator light illuminates and will
cycle on and off as the temperature is maintained, and in just approximately 45
seconds, the green ready light will also illuminate. The green light may cycle off, and
the pump will stop if the temperature is too low to generate steam.
Caution: Burns could occur from touching hot metal parts, hot water, or steam. Use
care when you turn a steam appliance upside down – there may be hot water in the
reservoir.
5. You are now ready to start steaming!
6. Hold your Steamer by the handle in vertical position with the head pointing toward the
fabric and away from you and your body.
Warning: Steam is hot. Always point steamer exit away from yourself, other persons,
pets, plants and walls. Never steam clothes while they are being worn.
7. With your free hand, pull the fabric tight and press the trigger switch as you move the
Steamer over the fabric.
8. You can use the trigger two ways:
a. Press the switch to generate steam and release it to pause the steam.
b. To get continuous steam for up to 24 minutes, you can press the trigger switch and
move it down to the lock down position.
9. Touch the fabric lightly with the heated press bar, moving it in a downward motion,
beginning at the top of the garment and moving downward.
Caution: The heated press bar gets hot, do not touch.
10. Repeat this step until fabric is wrinkle free.
Tip: For more difficult wrinkles, try steaming from the underside of the fabric.
11. When finished, move trigger switch up to release it from the lock down position and
slide switch to Off.
12. Place Steamer on a flat surface and unplug from electrical outlet.
13. Wait until Steamer has cooled and empty water tank.
Note: Always unplug the Steamer when not in use.
