Oster OT16RBS-049, Инструкция по эксплуатации

Страница: 5 / 16

ASSEMBLY INSTRUCTIONS
1. Assemble Base Halves (E) around
the cord. Refer to FIGURE 5.
2. Secure assembled base to the Fan
Housing with two thumb screws (F). Refer to FIGURE 5.
3. Secure Power Cord (G) as shown in
FIGURE 6.
4. Secure the Wiring Clip Slot (H) with the
remaining two Philips head screws. Refer to
FIGURE 6.
OPERATING INSTRUCTIONS
(SEE FIG. 2, 3, 4)
Remote Control: Remote Control requires 2 AAA batteries for operation. There is a slot
on the back of the unit (Refer to Fig. 2) to store the remote when not using.
A. Power/Speed Settings
Press = On, I, II, III, Off
B. Timer Control
Press = Turns Off in 1, 2, 4, 8 hours
C. Oscillation Control
Press = Oscillation On, Off
D. Natural Breeze, Sleep Modes
Press = Natural Breeze, Sleep Modes
Natural Breeze Mode will randomly cycle through the fan speed settings from High,
Medium, Low & OFF to simulate a natural breeze until the user turns the unit OFF.
Sleep Mode will automatically cycle through the fan speed settings, starting at
High for 3 hours, then Medium for 2 hours, then on Low until user turns the unit OFF.
CLEANING
1. Switch off and unplug the power cord before assembling or disassembling and cleaning.
2. Clean the fan with a soft cloth moistened with a mild soap solution.
3. Do not allow water to drip on or into the fan motor housing.
CAUTION:
Do not use harsh detergents, chemical cleaners, gasoline or solvents as they may
damage the surface finish of the plastic components. Also, do not immerse in liquids.
NOTE:
Unit must be unplugged for it to be fully off.
LEARNING MORE
For a wealth of information about your fan and other Oster
®
products, visit our website at www.oster.in.
4
OT16RBS-049_12EHM1.indd 4 9/13/12 2:00 PM