BEFORE USING FOR THE FIRST TIME
Read and follow all the instructions for this section on use and care and find a place to
keep this instruction manual ready for future reference.
For your convenience, record the complete model number (located at the bottom of the
motor) and the date you received the product, together with your purchase receipt and
attach to the warranty and service information. Retain in the event that the warranty
service is required.
NOTE: The use of attachments not recommended or sold by Sunbeam Products, Inc.
may cause fire, electrical shock, injury or damage to the product.
ASSEMBLY INSTRUCTIONS
Base / Pole Assembly
1. Extend the upper pole through the top of the lower pole and secure it firmly by turning
the height adjustment knob clockwise.
2. Remove the screw/washer/knob assembly from the pole by turning counter-clockwise.
3. Insert the screw/washer/knob assembly through the weight and base into the lower
pole, and turn clockwise until tight.
Fan Head Assembly
You are now ready to assemble the fan head.
1. Remove plastic sleeve on motor shaft, if included. Position the rear grill over the
motor shaft, making certain the 2 notches at the top and 1 notch at the bottom of the
rear grill fit over the protruding notches on the motor housing. Make sure the rear grill
fits securely against the motor housing.
2. Fasten the rear grill in place using the rear grill nut. Turn the nut clockwise and tighten
firmly.
3. Slide the fan blade, with the hollowed interior of the fan blade facing toward the rear
grill, firmly onto the motor shaft. Make sure that the fan blade rests on the pin on the
motor shaft.
NOTE: The shaft screw portion should protrude from the front of the blade.
4. Secure the fan blade onto the motor shaft by turning the blade cap counter-clockwise
(make sure the blade is firmly in position).
5. Center the front grill, ensuring the Oster™ logo is horizontal and parallel to the floor,
and press onto rear grill after aligning snaps.
Final Assembly
Fit fan head assembly onto pole/base assembly, and turn handscrew clockwise until tight.
INSTRUCTIONS FOR USE
3
OSF1613MW_MB_13ESM1.indd 4
7/18/13 8:53 AM
