English - 5
1. Plug into the appropriate electrical outlet.
2. Select the operating speed of HIGH ( ), MEDIUM ( ) or LOW ( ) by turning
the speed control knob to the appropriate setting.
3. To release negative ions into the filtered air, turn the Ionizer ( ) Control Knob to
ON and the light will illuminate.
4. The lonizer will not work unless Air Purifier is running.
5. For optimum air filtration, it is recommended to operate the Air Purifier continuously.
Its rugged motor has been designed to give many years of use.
1. Turn off and unplug the air purifier.
2. Open the air inlet grill and examine the black foam prefilter. Remove any dust or lint
and wash in warm soapy water. Rinse, air dry and place back into grill inlet.
3. Remove the used Aer1
®
filter(s) from the unit by pulling it gently towards you and
discard it. DO NOT attempt to clean the Aer1
®
filters.
4. Install the new Aer1
®
filter(s) into the unit. Before replacing the filter(s), make sure
that the hang tab is securely in place. The clip(s) can only be attached to the tabs on
the filter(s) one way. The filter clip(s) should easily slide onto the filter hang tab with
only a small amount of pressure. DO NOT use force while attaching the clip to the
filter. (Fig. 2)
5. Align the clip(s) on the side of Aer1
®
filter(s) with rails on the inside of the purifier
unit. Gently slide the filter(s) onto the rail.
6. Replace air inlet grill.
Fig. 2
TO OPERATE YOUR AIR PURIFIER
TO REPLACE YOUR FILTER
Содержание OAP706
Страница 8: ...NOTA...
Страница 15: ...NOTE...