OSS OSS-PCIe-HIB25-x16, Руководство по установке

Страница: 9 / 28

One Stop Systems
OSS-PCIe-HIB25x16| 9
1.4 PCIe Card Edge

In host mode, the add-in card will accept a clock as an input.

In target mode, the add-in card will drive a clock. It will also provide a reset output and a PS_ON# signal.
1.5 Power

Power is provided by the PCI-e card slot.

Power required by internal components of OSS-PCIe-HIB-38-x8 -QUAD is estimated to be 3.75 watts

Cable power is to be provided per PCIe cable specification. When an active cable (powered transceiver) is used, additional power is
required from the PCI-e card slot.

Power will be su3.3V, +3.3Vaux through Card Edge.

Some power rails will be derived from the onboard circuitry.
1.6 PCIe Cable Sideband signals

All Cable sideband signals CPERST#, CPWRON, CPRSNT#, CWAKE# to be connected per the PCIe Cable specification.

Additional isolation of signal CE_PWRON# (card edge power control) shall be provided by a physical switch.

This switch allows user to electrically isolate this signal from the card edge connector.
*The target card and expansion unit are powered UP instantly upon turning ON the host computer.
1.7
Pericom PI2EQX5804

Up to 5.0Gbps PCIe® 2.0 Serial ReDriver™

Supporting 8 differential channels or 4 lanes of PCIe Interface

Pin strapped and I2C configuration controls

Variable input and output termination

1:2 channel broadcast

Channel loop-back

Electrical Idle fully supported

Receiver detect and individual output control

Single supply voltage, 1.2V ± 0.05V

Power down modes

Packaging: 100-contact LBGA, Pb-free & Green
1.8 Link LEDS
The LINK status LEDs on the card indicates a successfully linked between host and target

Two Green LEDs: x1 / x4

Four Green LEDs: x8

Six Green LEDs: x16

NO LED: No link