7
4 fixtures are connected through the same type C, 10A circuit breaker.
7 fixtures are connected through the same type C, 16A circuit breaker.
The fixture must be grounded/earthed and be able to be isolated from AC
power. The AC power supply must incorporate a fuse or circuit breaker for fault
protection.
After connecting the fixture to power, run the on-
board test, using the “
Fixture
Text
” menu, to ensure that the fixture and each LED are functioning correctly.
See “Control menu”
on page 13.
CAUTION:
Do not open the fixture to replace the supplied power cable, or
connect the fixture to an electrical dimmer system, as this can damage it.
6.
Configuring the fixture
Set up the fixture using the control panel and LCD display at the arm side of the
fixture.
Navigate the menus and options using the arrow buttons and select items using
the Enter button. The options available are listed in “Control menu”
on page 13.
After powering on, the display shows the currently selected operating mode
and other information.
The fixture is set by default to be controlled in DMX mode.
Master/Slave configuration
You can set a fixture to operate as master fixture to another fixture (which then
becomes a slave fixture), or an entire group of fixtures (which then becomes
slave fixtures). The assigned slave fixture(s) will mimic the settings of the
master fixture. Use the
“
Auto Program -> Auto Color /
Auto Fade
”
menu to set
your fixture as master fixture, then other fixtures set to DMX mode as slave
fixture.
