Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1
Attach both Crossbars (4) to Side Frame (3) using two Bolts (7),
DO NOT FULLY TIGHTEN BOLTS (7)
.
Attach Shelf (2) to Side Frame (3) using two
Bolts (7),
DO NOT FULLY TIGHTEN BOLTS (7)
.
STEP 2
Attach second Side Frame (3) to Crossbars (4) and Shelf (2) using four Bolts (7),
DO NOT FULLY TIGHTEN BOLTS (7)
.
STEP 3
Carefully turn assembly to the upright position,
APPLY FIRM PRESSURE TO ALIGN & FULLY TIGHTEN ALL BOLTS (7)
. Screw four Cam Bolts (5)
into Top Panel (1). Slide exposed Cam Bolts (5) into holes in Crossbars. Insert four Cam Locks (6) into Crossbars,
FULLY TIGHTEN CAM LOCKS (6)
.
ATTENTION: MAKE SURE ALL BOLTS (7) & CAM LOCKS (6) ARE FULLY TIGHTENED BEFORE USING THIS PRODUCT.
SRA09
SIERRA END TABLE
ASSEMBLY INSTRUCTIONS
PART QTY
1.
Top Panel . . . . . . . . . . . . . . . . . . 1
2.
Shelf . . . . . . . . . . . . . . . . . . . . . . 1
3.
Side Frame . . . . . . . . . . . . . . . . . 2
4.
Crossbar . . . . . . . . . . . . . . . . . . . 2
5.
Cam Bolt . . . . . . . . . . . . . . . . . . . 4
6.
Cam Lock . . . . . . . . . . . . . . . . . . 4
7.
Bolt . . . . . . . . . . . . . . . . . . . . . . . 8
8.
Allen Wrench (not shown) . . . . . . 1
STEP 1
© Office Star Products October 2013
7
IMPORTANT NOTE:
1. Use hand tools only for assembly as power tools may cause damage.
2. Carefully remove any staples used for packaging.
3. Phillips Screwdriver also needed for assembly (not provided).
3
3
4
5
4
6
2
2
7
STEP 2
STEP 3
1
