OSO Solarcyl IM/SC2, Руководство по установке

Страница: 1 / 16

142044-03
This manual gives detailed advice for installation and should be read carefully
prior to fitting any unvented unit.
This OSO cylinder must be installed by a competent person and be installed in
compliance with the OSO Installation and Maintenance Instructions, all current
legislation, codes of practice and regulations governing the installation of unvented
hot water cylinders in force at the date of installation.
Components supplied with the unit for site fitting
(See also page 2 for component list)
* Multibloc valve, includes pressure reducing valve, line strainer, balanced cold water take off,
(for shower or bidet only)
check and expansion valve and 2 solar sensor pockets.
* Tundish
* 1/2’’F x 15 x 15 tee piece.
* Flexible hose.
* 3/4’’ x 22mm Elbow / Drain Cock.
* Blanking plug
* Motorised valve (indirect only).
Components factory fitted
* Immersion heater(s).
* Thermostats / thermal cut-out.
* Temperature and pressure relief valve.
Installation details
The OSO unvented unit is designed for use with supply pressure up to 16 bar. For pressures
over 16 bar an additional pressure reducing valve must be fitted in the supply pipe to the unit.
-1-
Health and Safety
Manual Handling Operations Regulations 1992 defines
manual handling as: “any transporting or supporting of a
load (including the lifting, putting down, pushing, pulling,
carrying or moving thereof) by hand or bodily force”. The
Regulations set no specific requirements such as weight
limits. However common sense still has to be used
based on an ergonomic approach for each individual.
DIMENSIONS AND WEIGHTS TABLE 1
PRODUCT REF. 200 250 300 380
HEIGHT 1150 1400 1600 2090
DIAMETER 580 580 580 580
WEIGHT EMPTY 48 60 64 82
MAX WEIGHT FULL 245 301 353 447
COIL SURFACE AREA - M²
UPPER COIL
0,4 0,4 0,4 0,8
LOWER COIL 0,8 0,8 0,8 0,8