S T E P 4 : S C R E W I N G T H E B O W L S T O T H E H E A D
Holding the bowl upright, hand screw the bowl
DQWLFORFNZLVHZLWKWKHȴOWHULQVLGHLWWRWKHȴOWHU
unit head to screw it on.
Once you have tightened it as much as you can by
hand, then use the spanner provided in the kit to
tighten it up.
IMPORTANT NOTE:
Do not over-tighten this. Only tighten a 1/4 turn at
a time (i.e. nip it up, don’t go crazy making it too
WLJKWLWZLOOEHYHU\KDUGRULPSRVVLEOHWRJHWR
otherwise!
S T E P 5 : C O N N E C T I N G T H E F I T T I N G S
The system is now ready to be
installed.
:HVXSSO\WZRPPSXVKȴWWLQJV
(with 1/2” male on the end). Use these
LI\RXZLVKWRLQVWDOOLWE\SXVKȴWWLQJD
15mm copper or plastic pipe to the
inlet and outlet.
The housing has brass threaded 1/2”
female (1/2” BSPP) ports so you can
install a 1/2” male hose straight in and
RXWRILWWRRRUXVHȋPDOHȴWWLQJV
to 15mm compression if you prefer.
Ensure that you use PFTE tape when
XVLQJWKHVXSSOLHGSXVKȴWWLQJV
ΖI\RXDUHXVLQJEUDVVPDOHȴWWLQJV
WKHQLWLVUHFRPPHQGHGWRXVH/RFWLWH
3)7(ȴEUH
