Oshkosh Corporation JLG ES1330L, Руководство по эксплуатации и безопасности

Страница: 45 / 98

SECTION 3 - MACHINE CONTROLS, INDICATORS, AND OPERATION
31217186
3-13
Overload Indicator (LSS)
The Overload Indicator indicates when the plat -
form has been overloaded. An audible alarm will
also signal when the platform is overloaded.
NOTE:
If the Overload Indicator is illuminated,
further elevation will be prevented.
Reduce the weight in the platform to not exceed the rated work -
load indicated on the capacity decal, then the controls will work
again.
Tilt Indicator Warning Light and Alarm
A red warning light on the control panel illumi -
nates and an audible alarm sounds when the
chassis is at or beyond the tilt cutout settings.
IF THE TILT INDICATOR WARNING LIGHT/ALARM IS ACTI -
VATED WHEN PLATFORM IS RAISED, LOWER PLATFORM AND DRIVE TO A SMOOTH
FIRM SURFACE WITHIN THE LIMITS OF THE MAXIMUM OPERATING SLOPE.
Variable Tilt - Platform Restricted Height
Indicator
This indicator shows the maximum allowable plat -
form elevation when the machine is within the
limits of the variable tilt envelope. When acti -
vated, allowable platform height will be shown in
one of three height ranges, depending on the
amount of tilt detected by the machine’s tilt sen -
sor. See Table 2-2 for tilt angle - platform operat -
ing height restrictions.
Horn
This push button switch, when pressed, permits
the operator to warn job site personnel when the
machine is operating in the area.