oset 16.0 ECO, Руководство пользователя

Страница: 20 / 36

19
DAILY MAINTENANCE AND CLEANING:
- Keep your OSET clean and dry. Clean using the recommended
procedure.
- Check all components for tightness and adjustment, including
handlebars, levers, axles, chain, brakes.
- Check the wheel spokes for tightness. It is normal for spokes to
loosen in operation. PLEASE CHECK after every initial ride, and
then regularly afterwards. If you need guidance please consult a
skilled wheel builder or call OSET customer service.
- Check the speed setting and the response setting before each ride.
- Check the tires for proper inflation. Also, inspect the tires for
damage.
CLEANING:
Cleaning and maintaining your OSET correctly will provide a more enjoyable
ownership and riding experience. By hand cleaning the bike, you can
simultaneously inspect all of the components. We recommend cleaning be done
with a damp cloth and slow running water.
Care must be taken when washing.
This is an electric machine, and water should never reach sensitive
components. If a hose is used, cover sensitive parts. Never use a power
washer as it may cause irreparable damage to sensitive components.
WARNING!
Water and electrical components do not mix! Do not get water onto the controller,
throttle or wiring. Failure to follow this instruction could result in permanent
damage, and could cause erratic machine behavior, leading to possible injury or
death.
FRONT WHEEL REMOVAL AND INSTALLATION:
Please refer to the section on assembling your OSET bike (page 13) for
information on installing the front wheel, and reverse the instructions for removal.
REAR WHEEL REMOVAL AND INSTALLATION:
1. Ensure power is switched off and the key removed.
2. Lift the bike onto a block or stand so the wheels are off the ground.
3. Loosen the axle bolts.
4. Loosen the chain adjustment nuts to the point where the wheel can be pushed
forward, and the chain slipped off to the right of the sprockets.
5. Pull back on the wheel to remove it.