oserio FEP-103 SERIES, Инструкция по эксплуатации

Страница: 10 / 20

14 15
Before Using the Monitor
1.8 EMC Guidance and Manufacturer's Declaration
Guidance and manufacturer’s declaration-electromagnetic immunity
Immunity test IEC 60601 test level Compliance level Electromagnetic environment-guidance
Conducted RF
IEC 61000-4-6 3 Vrms
150 KHz to 80 MHz Not applicable Portable and mobile RF communications equipment should be
used no closer to any part of the
FEP-103 including cables, than
the recommended separation distance calculated from the
equation applicable to the frequency of the transmitter.
NOTE1:
At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE2:
These guidelines may not apply in all situations.
Electromagnetic propagation is affected by absorption and
reflection from
structures, objects and people .
Field strengths from fixed transmitters, such as base
stations for radio (cellular/cordless) telephones and land
mobile radios, amateur radio, AM and FM radio broadcast
and TV broadcast cannot be predicted theoretically with
accuracy. To assess the electromagnetic environment due
to fixed RF transmitters, an electromagnetic site survey
should be considered. If the measured field strength in the
location in which the
FEP-103 should be observed to verify
normal operation. If abnormal performance is observed,
additional measures my be necessary, such as re-orienting
or relocating the
FEP-103 .
Over the frequency range 150 kHz to 80 MHz, field
strengths should be les than 3 V/m.
A.
B.
Radiated RF
IEC 61000-4-3 3 V/m
80MHz to 2.5 GHz 3 V/m
Where P is the maximum output power rating of the transmitter in
watts (W) according to the transmitter manufacturer and d is the
recommended separation distance in metres (m).
Interference may occur in the vicinity of
equipment marked with the following symbol:
Field strengths from fixed RF transmitters, as determined by an
electromagnetic site survey , should be less than the compliance level in
each frequency range .
b
a
Recommended separation distance:
d = 1.2 P
d = 1.2 P 80MHz to 800 MHz
d = 2.3 P 800MHz to 2.5 GHz