OSEE LMD9014, Руководство пользователя, Страница: 22 / 28

LMD9014 LCD MONITOR User Manual
— 18 —
*9. UMD TLY Mode
Use this setting when using Image Video tally control. Choose one of the following settings, in
conjunction with the Image Video controlling device.
T1, T2, T1T2, T2T1, T1-, T2-, T1T2-, T2T1- .
Consult Image Video documentation for further information.
*10. UMD Baud Rate
Use this setting to choose the baud rate. The baud rate must be set in conjunction with the
controlling device. Available baud rates are
2400 , 4800 , 9600 , 19200 , 38400 , 57600 , 115200 .
*11. Tally Source
The unit tally (OSD and LED) can be controlled in a variety of different ways. Use the Tally
Source setting to choose how tally is controlled:
n Standard
Use the Standard setting to control tally via contact closure on the DB-9 tally interface.
n Image Video HW
Use the Image Video HW setting to control Image Video tally states via contact closure
on the DB-9 tally interface. Contact closure of the
Red pin corresponds to Image Video
Tally 1 , and the Green pin maps to Image Video Tally 2 . Contact closure (ground)
corresponds to a LOW state, and open circuit corresponds to a HIGH state. This mode
requires the UMD Tally Mode parameter to be set. Consult Image Video documentation
for further information.
n Image Video 422
Use the Image Video 422 setting to control Image Video tally states via the Image Video
serial protocol. This mode requires the UMD Tally Mode parameter to be set. Consult
Image Video documentation for further information.
n St IV422
Use the Image Video 422 setting to control Image Video tally states via the Image Video
serial protocol, while controlling LED and OSD tally using contact closure on the DB-9
tally interface. This mode requires the UMD Tally Mode parameter to be set. Consult
Image Video documentation for further information.
n
TSL
Use the TSL setting to control OSD and LED tally via the TSL protocol.
5.6 USER CONTROL Sub-menu
PARAMETERS
Input Signal
Domain Range NOTE
CVBS SD-SDI HD-SDI
SCAN O O O NORMAL…UNDER SCAN Used to adjust the image
display scale.
Ÿ NORMAL: 95%
Ÿ UNDER SCAN:100%
SD ASPECT
1
O O X 4:3…16:9 Used to adjust the screen
Aspect Ratio.
H/V DELAY X O O OFF…H…V…H/V Used to observe the horizontal
and vertical sync signals at the
same time.
COLOR BAR
2
O O O ON…OFF
1. For “SD ASPECT” parameter: