AMPLIFIER OPERATION AND MAINTENANCE
7
Power-on – Trigger
Press the front panel power button. After a short pause the front panel LED indicators will light-up.
When the rear panel switch is set to TRIGGER the front panel indicator lights will be Yellow/Orange and the amp will be in Standby mode.
When a TRIGGER signal is present the amp will turn on and the indicator lights will be Blue. The amp will stay on as long as there is a
TRIGGER signal present. When the TRIGGER signal is removed, the amp will return to Standby and the front panel indicator lights will go to
Yellow/Orange.
To turn Off
Press the power button on the front panel, all lights will turn off.
Maintenance
If the amp requires cleaning, wipe with a clean, dampened soft cloth. Wipe dry immediately with a dry cloth. NEVER use benzene, thinner,
alcohol or any other volatile cleaning agents. Do not use abrasive cleaners, as they may damage the paint. Do not expose the amp to
insecticide, waxes, polishing agents, or an aerosol spray as moisture may enter the amp.
Service Information
Should you encounter any problems with your XA amplifier please reset the power by switching off and un-plugging the amp. Re-check all
connections from Processors or AVR’s and to the speakers. Turn on the amp again and refer to the ‘Amplifier Operation and Maintenance’
instructions. If a problem still exists, contact OSD Nero’s customer service department at OSDAUDIO.COM.
