Osaki Pro Maestro, Инструкция по эксплуатации

Страница: 26 / 30

This product will stop upon any obstruction or a too
large of a force preventing from operating.
If an issue occurs, inspect and trouble shoot according to the corresponding method
below.
As a safety protocol the massage heads will stop if
pressure/weight load has exceeded its limit.
If the problem is not resolved, contact the manufacturer for further instructions or service.
The chair is not functioning
(massaging).
The power line or the power
plug is abnormally warm to
hot.
The roller heads are still
warm after turning off the
heat. Is the product is
damaged.
To avoid potentially over heating or damaging the massage mechanism
the chair is designed to automatically shut off if over strained or over
heated. The remote will flash a few times and then shut off as a safety
measure. If this has occurred turn off the power switch from the back,
allow for 30 sec. And power back on. If the weight capacity of 260 lbs is
not exceeded, unplug from the outlet and notify the manufacturer.
If all screen and buttons are flickering and the backrest or the footrest
has stopped, turn off the power supply and turn back on 10 seconds.
Be sure there are no obstructions in the way of the footrest or the
backrest rolling mechanism.
If your head is not properly placed against the backrest during the
computer body scan, it may result in an incorrect reading, causing the
rollers to start a lower position causing the massage to be inaccurate.
If this occurs turn off the power from the remote and start over again to
get a proper reading.
This is a normal function of the massage mechanism as it programmed
to massage alternating locations from the right side during certain
intervals of the program.
The power line is disconnected.
The power switch is not turned on.
If no program is selected after turning, the chair will pause and shut
down. Turn off and restart.
Because the roller heads heat up it will take some time for the residual
heat to dissipate.
If the massage heads are mildly warm, the rollers may be admitting
heat created by the friction from the massage.