'
Connect the modular plug of the Infrared receiver to the modular jack
(
Remove the dust, water, oil and moist on the location, and stick the Infrared receiver tightly,
peeling the coated paper off. The location should be where the signal of the infrared remote
controller can reach. Avoid the direct sunshine area.
Fitting the Infrared receiver
Things to know:
When the reception is weak because of the direct sunshine, the infrared receiver location should be changed.
There are locations where the infrared receiver cannot be stuck.
Use the spare sticker, when the adhesive power of the pad is weak.
Make sure the power is off when you connect it to the screen. It
may destroy the product.
Plug in the Infrared receiver plug tightly. If not, it may cause
mal-functioning
.
Please pull out the back panel of the remote controller, and put two dry batteries
(size AAA).
Dry batteries
Change the two batteries to the new ones
when the signal is weak.
Take out all the batteries when you do not
use it for long to avoid the liquid leakage
damage
Do not use rechargeable batteries.
Preparation of the remote controller
Batteries (UM4)
Make sure
and
are correct.
Remote controller
Do not drop, throw away, or put water on it, or it
may cause the breakdown.
Handle the remote controller carefully.
Please operate it to the direction of the infrared
receiver
Modular type
Infrared
receiver
The operation range of Infrared remote controller
Infrared receiver
