Oryx sca3600, Руководство пользователя

Страница: 15 / 25

15
Completing the cleaning process
Removing parts from the SCA
When the parts are clean, they can be removed from the SCA. Halt the cleaning cycle by
pressing the button if removing the parts before the timer has finished count down.
Open the SCA lids and slowly lift the large basket from the cleaning solution. Rest the
basket over the tank by setting the basket lugs (pins) on the support brackets and inner
rim of the tank.
Protective gloves and eyewear should always be worn when lifting the basket from the
tank or handling wet parts prior to rinsing.
Des gants de protection et des lunettes protectrices devraient être portés en tout temps
lorsque vous soulevez le panier du réservoir ou lorsque vous manipulez des pièces
mouillées avant qu’elles n’aient été rincées .
Let the basket rest above the tank while draining. After draining, remove the parts from
the basket and rinse them with water to remove any residual cleaning solution. Air dry
or pat dry with a soft cloth or paper towels.
Readiness for the next cleaning cycle
After removing recently cleaned parts, lower the large basket into the tank and close
the lids. If the SCA is used periodically, use the
50⁰C temperature preset to maintain the
water at an elevated temperature. This will shorten the time required to heat the water
to an optimal cleaning temperature of 70⁰C or 85⁰C while still conserving energy.
Alternatively, the SCA can be turned off by pressing the ON/OFF rocker switch at the
back of the unit.
If the SCA will not be used for an extended period of time, all liquid should be drained
from the tank and the power cord removed from the wall receptacle.