4.2. Binding
A new socket must be bound to the control panel in order to successfully transmit commands
from receiver.
To register a socket, do the following:
1. In the control panel configuration, pre-set the required number of radio outputs, their
type, group membership and other parameters;
2. Turn on the control panel in the operating mode and switch to the desired control
panel’s group;
3. Switch the control panel to the wireless outputs binding mode (see the corresponding
control panel programming manual);
4. Plug the Socket-R into a wall outlet;
5. Switch the socket to the binding mode by pressing and holding the button on its body
for more than 10 seconds (until the blinking green – the signal "
Binding
");
6. Binding will processed automatically and, if successful, ends by turning on the red LED
for 2…3 seconds (signal "
Bound
").
The socket waits 70 seconds for binding. To reinitialize the binding process, press and hold
the button again.
4.3. Wireless signal strength
The socket should be in the radio visibility zone of its receiver, therefore, after binding, before
installation at the facility, it is strongly recommended to recognize the wireless signal strength.
To do this, turn on and place the socket and the control panel in the intended installation lo-
cations, and then press and hold the socket button for 1…2 seconds. The socket indicator display
the wireless signal strength as follows:
LED color
Number of blinks
Signal strength
Green
3
Best
2
Good
1
Poor
Red
4
No connection
If the signal strength is poor or there is no connection, it is recommended to change the loca-
tion of the socket and repeat the above process in order to form a reliable reception map.
5. Maintenance
The product does not require maintenance.
6. Operating conditions
1. Socket is designed for continuous operation.
2. Socket shall be used at the temperature of –20°С to +55°С and relative humidity of 5% to
85%.
3. If the transportation conditions differ from the operating conditions, then the socket must
be kept in the operating conditions for 2…6 hours before switching on.
Relay-R
Version en_2
5
