Fireplaces
MODEL
LEDFP-3-43 | LEDFP-3-50 | LEDFP-3-60
Instruction Manual
OPERATION
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
[email protected]
www.ortechindustries.com
375 Admiral Blvd
Missis
s
auga
,
ON L5T 2N1
TEMPERATURE LIMITING CONTROL
READ AND UNDERSTAND THIS ENTIRE OWNER'S MANUAL, INCLUDING ALL SAFETY INFORMATION, BEFORE PLUGGING
IN OR USING THIS PRODUCT. FAILURE TO DO SO COULD RESULT IN ELECTRIC SHOCK, FIRE, SERIOUS INJURY, OR DEATH
1.
Plug the power cord into a 110-120V AC outlet (
read the WARNING, the very first page of this instruction manual)
2.
Make sure the outlet is in good condition and that the plug is not loose
3.
Never exceed the maximum amperage for the circuit
4.
DO NOT plug other appliances into the same circuit
Power
This electric fireplace can be operated by the CONTROL PANEL / TOUCH PANEL, or by the battery-powered REMOTE CONTROL.
The operation and functions of the two methods are the same.
Before operating , please review the WARNING on the very first page of this manual, and heed all warnings.
Method of Operation
This heater is equipped with a Temperature Limiting Control. Should the heater reach an unsafe temperature, the heater will
automatically turn OFF. To reset:
1.
Unplug the power cord from the outlet
2.
Turn the ON/OFF switch on the CONTROL PANEL to OFF.
Wait 5 minutes
3.
Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint. If they are, use a vacuum to clean
the vent areas
4. With the POWER switch in the OFF position, plug the power cord back into the outlet
5. If the problem continues, have your outlet and wiring inspected by a professional
REMOTE CONTROL BATTERY INFORMATION
This remote control uses one CR2025 battery (included)
** When the heater is first turned on, a slight oder may be present. This is normal and should not occur again unless the heater
is not used for a long period of time
**
To improve operation, aim the remote control at the front of the fireplace. DO NOT press the buttons too quickly. Give the
unit time to respond to each command
