5.18 Calibration
radEAGLE
User Manual
5.18 Calibration
This screen (Fig.
, p.
) shows a partial spectrum and some additional information you
can use to inspect and trigger the calibration of your
radEAGLE
.
For additional information refer to appendix
, p.
A simpler version of calibration is available too, see
, p.
.
Please place a suitable calibration source (
40
K or
137
Cs) in front of the detector before
proceeding.
Current Dose Rate
Current Count Rate
Nuclide for Calibration
Theoretical Peak Position
Measured Peak Position
Current Peak Fit
Raw Spectrum
Measurement Progress
Figure 73:
The calibration screen
Current Dose Rate
Current Count Rate
Nuclide for Calibration
Theoretical Peak Position
Measured Peak Position
Resolution After Calibration
Peak Fit
Raw Spectrum
Measurement Finished
Figure 74:
The calibration screen after measurement
Settings and Commands
Next
Reveal the next available command for the left key.
Source
Specify the source to be used for calibration. Available are
40
K and
137
Cs.
68/147
Software 3.2.12 • Document 3.3.0o
© innoRIID GmbH • 2019-04-11
Содержание radEAGLE
