ORTEC Fission Meter FM-P3, Руководство пользователя

Страница: 14 / 56

ORTEC
®
Fission Meter
®
(FM-P3) Portable Neutron Source Identification System 931026D / 060118
6
1.3.2.3 T
URNING THE
P
ANEL
A
SSEMBLY
O
N AND
O
FF
To turn the panel assembly on, press and hold the ON button for approximately 2 seconds. The readout on
top of the master panel activates, displaying the current neutron count rate in cps and the voltages for the
two battery tubes, as shown in Figure 7.
Figure 7. Panel Status Readout.
To turn the panel assembly off, press and hold the ON button for 2 – 3 seconds until the display goes blank.
1.3.2.4 U
NFOLDING THE
P
ANEL
A
SSEMBLY
In Mobile Search Mode you will generally keep the panel assembly folded, thin (detector) side out, as
indicated by the markings on the carrying case.
For measurements in Static and Characterization modes, use the handles on the sides of the panel assemblies
(not the top handles) to unfold the panel assembly, turn the thin sides toward the item to be measured, and
enfo
ld (“clamshell”) the item as much as possible, as shown in Figure 16 on page 16.
1.4 Transferring Data from the Trimble Ranger to Another Computer
The easiest way to transfer data from the Ranger to a computer is by using the Micro SD card and USB adaptor
provided. Additionally, the Micro SD card can be used in an Android-based mobile phone to transfer data
directly by email to the desired recipient.
1.4.1 Connecting the Trimble Ranger Directly to Another Computer
The Fission Meter is designed as a standalone system, however, there are cases in which it will be useful or
necessary to connect with another computer. For example, you might wish to connect to a computer via
cable in order to transmit data via email, perhaps for expert analysis. In addition, unless your Ranger is
configured for wireless networking, you must connect to a computer to install Fission Meter software
updates or to reinstall/repair the original Fission Meter software. You might also wish to transfer data files
from the Ranger to another computer.
NOTE The Ranger is a standard Windows Mobile 6.5 computer. Any of the standard communication
techniques (wireless networking, etc.) can be used to establish communication with the internet for remote
transfer of email and files.
IMPORTANT: The battery voltage on each panel must be >8.5 V or the Fission Meter may not function
accurately!
I
IMPORTANT Before connecting the Ranger to another computer for the first time , install Windows Mobile
Device Center on the host computer first . Otherwise, the Ranger might not communicate properly with
the computer. Contact our Global Service Center if you need assistance.