ORTAL Clear 100 LS, Руководство по установке и эксплуатации

Страница: 5 / 115

5
WARNING
: Glass Handling
The glass must ONLY be removed by an authorized &/or qualified installer. The
authorized technician should ONLY remove the glass with the glass vacuum holders
supplied by the manufacturer. Lower the glass to rest in the special
wooden/polyurethane support provided, and fit the second support to the upper edge of
the glass. This is to prevent damage to the glass edges.
Step 1. Place the support on the floor below the glass to be removed.
Step 2. Remove the glass using the vacuum holder, and immediately place it in the
support.
Step 3. Place the second support on the upper edge of the glass. The glass can
now be rested safely.
WARNING
: Electrical Grounding
These Direct Vent appliances must be electrically grounded in accordance with the
local codes or, in the absence of local codes, with National Electric code, ANSI/NFPA
70, or the Canadian Electric Code, CSA C22.1.
WARNING
: Gas Appliance
This appliance is only for use with the type of gas indicated on the rating plate. These
appliances are not convertible for use with other gases, unless a certified kit is used
and the conversion is performed by an authorized qualified technician.
Applicable standards are Vented Gas fireplace heaters ANSI Z21.88 / CSA 2.33a and
gas-fired appliances for use at high altitudes CAN/CGA 2.17-M91.
WARNING
: Installation and Service
Installation and service must be performed by an authorized qualified installer service
agency or gas supplier.
Any alteration to the product that causes soot or carbon to form and results in damage
is not the responsibility of the manufacturer.
In the case of models supplied with a door fitted in the frame of the heater, ONLY an
authorized qualified installer may open this door. The end user must NOT open the
door, as this may be unsafe and may result in voiding the manufacturer’s warranty.