Orlaco RadarEye, Системное руководство

Страница: 5 / 28

5 SM0974110 A 05
2.3. Cables
The connection between the Interface and the Sensors is
done with cables with twisted pair and power wires for the
Sensors. These cables with molded M12 connectors are
available in different lengths, see figure 3.
Connection between the Interface and first Sensor is done
with the cable with a green color marking (cable type D).
The connection between a Primary Sensor and a Secondary
Sensor is done with the cable with red color marking (cable
type K).
The difference between the green and the red cable is the
number of connections. In the green marked cable 4 wires
are connected and in the red marked cable 5 wires are con-
nected, the extra connection is for communication between
Primary and Secondary Sensor.
For the camera connection the Orlaco (Uni or Dynamic) 4p
cables are used.
2.4 SRD sensor CAN Horizontal 0004310 and SRD sensor
CAN Vertical 0004320
The SRD sensor CAN Horizontal is one Sensor, article No.
0004310 (freq.=24 GHz) with a theoretical detection angle of
70° horizontal. The SRD sensor CAN Vertical is one Sensor,
article No. 0004320 (freq.=24 GHz) with a theoretical detec-
tion angle of 11° vertical.
Sensitivity is less outside 70 degrees, but signal level is still
high enough for accurate detection until 90 degrees.
The vertical detection zone is 11°.
When installing the Sensor CAN Horizontal; the orientation
of the antenna must be horizontal. The milling lines at the
surface of the Sensor indicate the antenna position and need
to be in line with the horizon. When installing the Sensor
CAN Vertical; the orientation of the antenna must be vertical.
For mounting four M4 Vibration dampers are included, see
figure 4.
2.5 Terminator 0350110
The CAN bus must be terminated at both ends by a 120-ohm
resistor placed across CAN_H and CAN_L so that reflections
of signals are avoided.
Therefore the terminator is supplied in the sets and the main
terminator activated in the monitor (Default via OSD set-
tings), see figure 5.
2.6. Mounting brackets 0401330 and 0401320
To mount the Sensors there are two mounting brackets avail-
able. Article No. 0401330 is a bracket to be used to mount
one Sensor and is applied for corner rear mounting. Article
No. 0401320 is the bracket used to mount two Sensors (Pri-
mary/Secondary) for center rear mounting, see figure 6.
Figure 3
Figure 4
Figure 5
Figure 6
System manual