4
IM0973510 A 12
R
Min. bend radius (R) = 50mm
Units in mm
M6 x 20
6,5
25
55
19
1. Mounting and connecting Camera
Overhead
Horizontal
1.2. Camera attachment.
Recommendation:
The bracket should be tightened with a torque of 6 Nm nominal.
Tighten by hand or with very low speed.
1.1. Universal camera bracket.
o o a
Vertical
Sloping surfaces
Installation manual
17
6. Disposal
Disassembly, removal and disposal. Local regulations for dealing with waste
must be followed when disposing of disassembled components or entire units.
7. General terms and conditions
Orlaco Products BV is not liable for damage resulting from inadequate servicing,
incorrect usage or alterations made to the equipment without informing the
manufacturer in writing.
This installation manual has been made available by Orlaco Products BV.
All rights reserved. No part of this manual may be reproduced and/or made
public in printed form, in photocopy form or on microfilm, or in any other way,
without the prior written permission of Orlaco. This also applies to the associ-
ated drawings and figures.
Orlaco reserves the right to make changes to components at any time without
informing customers beforehand or directly. All dimensions given are for com-
mercial purposes.
For information regarding repairs that is not covered in this manual, please
contact the Orlaco Products BV service department.
This manual has been prepared with all due care and attention. However, Orlaco
Products BV cannot be held responsible for any errors in this manual or any
consequences thereof.
Installation manual