2
Safety
In order to guarantee safe operation, these safety
instructions must be read before you start using this
equipment.
•
Do not open the enclosure. This can cause damage,
short-circuiting or electrical shocks.
•
Do not expose the equipment to extreme temperatures.
This can cause deformation of the enclosure or damage
to internal components.
•
Repairs may only be undertaken by the manufacturer.
•
The equipment must be installed as shown in this
manual.
Preface
Before you start using this equipment, please read this manual
carefully and follow all instructions. If you have any questions or issues
concerning the operation of this equipment, consult the relevant section
in the manual or contact the Service department.
All data subject to change without notice. All dimensions are for commer-
cial purpose only. The camera/display systems comply with the latest CE,
ADR, EMC and mirror-directive regulations. All products are manufac-
tured in accordance with the ISO 9001 quality management system, ISO/
TS16949 quality automotive and ISO 14001 environmental management
systems.
Contents
Page
1.
Introduction
3
2.
MAN TGS, TGX Corner shields
3
2.1.
Step1
3
2.2.
Step2
4
3.
Additional work for cabling.
6
4.
Maintenance and cleaning
7
5.
Disposal
7
6.
General terms and conditions
7
7.
Release notes
7
Available documentation
IM0973520 Set Camera HMOS CornerEye®
DS0963141-0402620 Bracket HMOS CornerEye®
Side view
Top view
40
60
30
30
7mm
7mm
Hole for Camera cable
Hole Pattern MAN TGS and TGX
Hole for Bolt M6
Hole for Bolt M6
23mm
2
Bolts 2x M6 x 35
The grommet is inserted
as a spare part in the bracket,
remove for any application
Extension
Please use the included drilling pattern on pages 4 to 5
Manual drilling pattern
IM0973604 A 02
MAN Drilling template CornerEye
®
LHD
7
Manual drilling pattern
IM0973604 A 02
4. Maintenance and cleaning
This product can only work correctly by using fluid for glass cleaning
used in the automotive industry with desired temperature of -40°C to
+85°C. Do absolutely not use aggressive chemicals or abrasive cleaning
agents.
5. Disposal
Disassembly, removal and disposal. Local regulations for dealing with
waste must be followed when disposing of disassembled components or
entire units.
6. General terms and conditions
The manufacturer is not liable for damage resulting from inadequate
installation or alterations made to the equipment without informing the
manufacturer in writing.
This installation manual has been made available by the manufacturer.
All rights reserved. No part of this manual may be reproduced and/or
made public in printed form, in photocopy form or digital, or in any other
way, without the prior written permission of the manufacturer. This also
applies to the associated drawings and figures.
The manufacturer reserves the right to make changes to components at
any time without informing customers beforehand or directly.
All dimensions given are for commercial purposes.
This manual has been prepared with all due care and attention.
However, the manufacturer cannot be held responsible for any errors in
this manual or any consequences thereof.
7. Release notes
A 01.
First edition; May 2017.
A 02.
Drawing page 4,5 changed; August 2017.
