Orival OR-02-PE, Руководство по эксплуатации и обслуживанию

Страница: 10 / 51

ORIVAL, INC. • 213 S. Van Brunt St. • Englewood, NJ 07631 • (201) 568-3311
4
SECTION 3 - INSTALLATION PROCEDURES
3.1 - ASSEMBLY PRIOR TO INSTALLATION
The rinse valves, hydraulic piston and solenoid valve for the filter have been packed
separately in the filter carton and must be installed prior to start-up of the filter. To
ensure proper installation, follow the subsequent procedures carefully.
A. Rinse Valve Mounting
(See EQUIPMENT DATA SHEET for number of valves supplied).
Rinse valves are supplied with a 2’’ nipple attached.
1. Attach each rinse valve’s 2" nipple to the 2" port on the hydraulic motor
chamber end of the filter – see Figure 3.1.
2. Attach a 2’’ drain line to an adequately sized drain as described in
Section 3.2B as shown in dashed lines in Figure 3.1.
NOTE: RINSE VALVES MAY BE ROTATED IN THEIR PORTS TO FACILITATE
CONNECTION OF THE DRAIN LINES
HEXAGONAL OPENING
HYDRAULIC MOTOR
CHAMBER COVER
Figure 3.1 – Correct Valve & Piston Orientation.
B. Hydraulic Piston Mounting - See Figure 3.1 (if applicable)
1. Slide the white PVC shield off the end of the hydraulic piston after cutting the
tie-wrap and threading the drain fitting from the shield.
2. Remove the six nuts from the studs at the back end of the filter housing.
3. Remove the bolts, nuts and washers securing the hydraulic motor chamber
cover, then remove the cover.