9
2. Connect EBM port C to UPS port D with one of the accessory wire.
3.5 UPS Initial Startup
To start up the UPS:
1. Verify that the internal batteries are connected. If optional EBMs are installed, verify that the EBMs are
connected to the UPS.
2. Plug the equipment to be protected onto the UPS, but do not turn on the protected equipment.
3. Plug in the UPS input power cord. The UPS front panel display illuminates and UPS status display shows
“STbY”
4. Press and hold the button
more than 3 seconds. The UPS status display changes to “NORM”
6. Check the UPS display for active alarms or notices. Resolve any active alarms before continuing. See
“Troubleshooting”
8. If optional EBMs are installed, see “Configuring UPS for EBM numbers” on page 17 to set the number of
installed EBMs.
9. To change any other factory-set defaults, see “Operation”
Note:
At initial startup, the UPS sets system frequency according to input line frequency.
