Orion L77-17, Инструкция по эксплуатации

Страница: 19 / 41

SECTION 3
Manual Operation
3.1 Turntable Jog
To rotate the Turntable using the TURNTABLE JOG keypad, the machine must be
stopped (out of wrapping cycle). If a cycle is being processed, this keypad is disabled.
When the JOG keypad is pressed, the turntable turns at a preset speed (Low) until the
keypad is released. Screen displays JOG.
3.2 Carriage Jog UP & DOWN
To move the carriage up or down using the CARRIAGE UP and CARRIAGE DOWN
keypad, the machine must be stopped (out of wrapping cycle). If a cycle is being
processed, those two keypads are disabled.
When the CARRIAGE UP keypad is pressed, the carriage will go up until the keypad is
released or the carriage top limit switch is activated. Screen displays UP.
When the CARRIAGE DOWN keypad is pressed, the carriage will go down and it will
stop only when carriage down keypad is pressed again or carriage up keypad is
pressed, or when it reaches the carriage bottom limit switch. Screen displays dn.
A delay of one (1) second must elapse before the carriage can reverse direction.
SECTION 4
Programming Wrapping Pattern
This section describes how to change all programmable parameters and values. Also,
operator can select up to three (3) wrapping modes by using the spiral keypad and the
function parameter P02:
•
Spiral Up Only
•
Spiral Up/Down with top wraps first
•
Spiral Up/Down with bottom wraps first.
4.1 Top & Bottom Wraps
There are two settings for the number of wraps. The numbers of wraps are executed
at the bottom and at the top of the load.
To select the top wrap variable, the set # wraps keypad must be pressed once, this
turns ON the LED located beside the top right corner of the keypad. This indicates that
the top wrap variable is selected. By using the UP or DOWN arrows the value can be
changed. The value can be set from 1 to 10.
To select the bottom wrap variable, the set # wraps keypad must be pressed twice or
until the LED located beside the bottom right corner is ON. This indicates that the
bottom wrap variable is selected. By using the UP or DOWN arrows the value can be
changed. The value can be set from 1 to 10.
For changes “on-the-fly”, a delay of 1 (one) second must elapse before new top/bottom
wraps settings will be effective
Page 6