4
© 2012 MD Audio Engineering—all rights reserved
INSTALLING THE MID/WOOFERS
Step 1: Determine where the speakers will be mounted. Make sure there is a flat area large
enough for the speakers to fit properly. An uneven mounting surface can damage the
driver.
Step 2: Check to make sure the space you have chosen for the speakers will not interfere with
the operation of the vehicle.
Step 3: Using the supplied template guide, mark the mounting hole and mounting screw hole
locations with a pen for each speaker.
Step 4: Cut the holes for the speaker. When using correctly sized factory locations, this step
can be passed. A hole can be cut either with a pair of metal tin snips, an air or jig saw,
or with a hole saw corresponding to the size of the midrange listed below.
o 4-3/4" Hole Saw (5-1/4" woofer installation)
o 5" Hole Saw (6-1/2" woofer installation)
WARNING:
Check for clearance of window mechanisms and electrical wires BEFORE you drill.
Step 5: Run the speaker wire to the speakers. Make sure to keep wires away from sharp metal
or other edges. When passing through metal, use a protective grommet.
Step 6: Pre-drill mounting screw holes using a 1/8" drill bit.
WARNING:
Check for clearance of window mechanisms and electrical wires BEFORE you drill.
Step 7: Pull the wire through the speaker opening and connect to the speaker. Be sure to
observe proper mid/woofer polarity during this process.
Step 8: Mount the speaker- Place the speaker and the grille in the installation hole. Align the
mounting screw holes and drive in the four mounting screws.
Screws
Speaker
Panel
Wiring
Harness
Figure 3
Figura 3
Abbildung 3
Содержание Component Speaker XTR52
Страница 1: ...Component Speaker MODEL XTR52 XTR62 OWNER S MANUAL ...
Страница 2: ......
Страница 15: ......