Orion 2005-8899999, Инструкция по эксплуатации

Страница: 8 / 40

MACHINE UNLOADING
INSPECTION & INSTALLATION
UNLOADING
Machine can be easily unloaded and transported by a forklift with a minimum capacity of
2500 lbs.
1. Carefully insert the forks into the lifting tubes to the maximum possible depth. Depending
on the model, a forklift access may be either at the turntable end of the machine frame, the
tower end or both.
In case of the mongoose machine enter the forks under the frame or
insert the forks in the tube brackets welded to the top of the machine.
2. Lift the machine (or other part of system) only to the necessary height to move it with no
bouncing or friction on the floor.
2a. On the mongoose machines use the brackets welded on the top part of the machine.
3. Sit the machine down assuring uniform contact with the floor, which is necessary to
ensure correct and smooth operation.
3a. Mongoose type machines (M66, M67) have to be attached on the bracket or on the
stand (collapsible or anchored to the floor). The M55 has it’s own supporting frame which
allows the machine to stand independently.
INSPECTION
1. Remove all packing and supporting additions - these may include the blocks under the
carriage and the restraining bar over the table.
NOTE: when removing the stretchwrap film covering the machine, care must be taken not
to cut any of the electrical wires and/ or polyurethane covering on the film carriage rollers.
2. Perform a visual inspection of the electrical and mechanical parts for loosened joints and /
or broken connections. Any suspected shipping damage must be reported immediately to
the freight carrier. Any transport damage cannot be claimed to Orion Packaging Inc.
Items that are vulnerable to damage and must be inspected are as follows:
- Motors and transmissions
- Junction boxes
- Electrical conduits
- Proximity and limit switches
- Photocells
3. Check under the turntable to ensure that there is no crippling of the movable parts i.e.
casters, center axle or drive assembly.
4.Verify the following:
- Turntable or rotary arm drive system to confirm that the reducer to drive the chain is snug
and properly aligned.
- Verify the wires tight conduits for crushed sections or loose fittings.
- Verify the film carriage to be sure that it is correctly aligned with the tower
- Verify the tension on the lift chain.
- Verify all the dials and knobs on the control panel for smooth action.