Cobb Rise & Fall
Pendant Light
Cobb
E26
A
BALL
LAMP GUIDANCE
TYPE*
WATTAGE**
BASE
SHAPE
INCANDESCENT
CFL
ECO-HALOGEN
LED
120V ac 60Hz
Hanging Instructions
Tools Required For Installation
IP20
* Warm white (2700k) low energy lamps recommended.
** Wattage value provided as a guide to suitable lamps. Lower wattage than stated may be used.
US-FP189
Small
US-FP350
Large
100W MAX
20W
n/a
18W
THIS PRODUCT IS MADE FROM FINE BONE CHINA. EXCESSIVE FORCE USED
DURING INSTALLATION OR OPERATION CAN CAUSE DAMAGES OR BREAKAGES.
PLEASE READ THE INSTRUCTIONS ON THE REVERSE BEFORE YOU BEGIN INSTALLING YOUR LIGHT
Max.
Drop
Min.
Drop
Refer to diagrams on opposite page.
STEP 1
- Determine the maximum drop (the lowest the shade will hang from the ceiling) and total movement (rise and
fall) of the shade required (see fig.1). Remember: the larger the maximum drop, the larger the minimum drop
(the highest the shade will hang without the weight hitting the shade) and vice versa.
- The drop can be controlled by shortening or lengthening the amount of flex (A) that is allowed to pass though
the cord grip (C)- see fig.2. Once you are happy with drop, allow 10cm from cord grip (C) in order to make
electrical connection, then remove excess flex (see point 7 on reverse).
STEP 2
- Mark fixing holes through ceiling plate (B) before drilling holes, see point 6 on reverse. Take care to mark the
centre of each hole, so when installing, fixing screws don’t put any pressure on base.
STEP 3
- Make electrical connection- see points 8 to 11 on the reverse.
STEP 4
Screw ceiling plate to ceiling with washers (F) in place (see fig. 3),
taking care not to apply excessive force
when screwing in screws as this can damage the china ceiling rose.
DO NOT USE POWER TOOLS.
To adjust drop of shade (see fig.4), gently pull the shade (I) downwards (while also holding the flex above the
shade) to increase the drop and push gently upwards (taking care not to hit the weight (H) as it falls) to
decrease the drop.
!
!
Contents
Installation Diagram
- Junction box
- 3 x UL wire nuts
- Screwdriver
Contents
Tools/Hardware Required
1
2
3
4
Ceiling Rose
Weight
Shade
2 x washers
1
4
Fig.1
Fig.2
Fig.3
Fig.4
Increase Drop
Decrease Drop
A
B
C
I
J
Junction Box*
Main supply
Wire nuts*
Luminaire cable
Cord Restraint
Ceiling Rose
A
B
C
D
E
F
G
H
I
Washer
Junction box screws*
Weight
J Shade
*not supplied
2
3
A
C
D
E
F
G
B
H
- Cross head screwdriver
- Junction Box
- Wire Nuts
- Small flat-head screwdriver
- Drill (if holes are required)
