Page 2
Contents
I N T R O D U C T I O N ( R E A D
C A R E F U L L Y )
Congratulations on choosing your Origin Live turntable. You
now have one of the finest sounding turntables available – not
only will it provide an extraordinary level of performance but
also reliability and low maintenance.
This manual covers variations of the Aurora Gold produced
over the years and so some photos are only representative.
The portions of the instructions printed in
light grey
are
optional reading for more in depth knowledge if necessary. It
is critical that the remainder of the instructions are read fully
to achieve the full performance from your turntable. There are
aspects of the deck that run contrary to what you may expect,
so before altering anything it is important to have fully read
the manual or degradation will result.
The Aurora Gold turntable is simple to set up. If you have
a problem please refer to the instructions. If your problem
persists you should speak to your dealer or have a look at the
Origin Live web site www.originlive.com under “general
information” then “technical support” from the drop down list.
The instructions are written for owners with no previous
experience of turntables. Some sections may therefore appear
lengthy, as they need to cater for all potential questions. When
reading the instructions refer to the various diagrams for part
names and clarity.
The deck can take approximately 15 minutes to set up
depending on your expertise. The dc regulator electronics may
initially encounter speed drift when first started (if they have
not been run in) and may need at least 4 hours to run in before
the speed can finally be set with accuracy.
We wish you an increased musical experience with your Aurora
Gold turntable.
Parts list
Plinth
Turntable bag
o
Belt
o
1 large & 1 small cable clip and attachment
nylock nut and M4 x 16 bolt (usually on
deck)
o
Oil Bottle
o
3mm Allen key
&
2.5 mm Allen key
o
3 cork discs for levelling if necessary
o
Cork ring for arm
o
Threaded VAT adjuster
o
4mm spacer for 3 point mounting
Platter
Sub-chassis
Motor pod
Control box
Transformer for 230 volt or 110 volt mains supply
Arm (optional), alignment gauge, but no arm instruction
sheets as included in deck instructions
P A P E R W O R K
Turntable instructions
& Strobe card