11
D E E P CO L L E CT I O N ™ I N STA L L AT I O N US E R M A N UA L
DELAY
The DELAY parameter enables you to delay playback of the
Deep
TM
subwoofer audio signal. This is particularly helpful when
the Deep
TM
subwoofer is placed closer to the listening position
than the rest of your speakers. Increasing the delay time by
1 millisecond will have the same effect as moving the Deep
TM
subwoofer approximately 13 inches (33 cm) further away from
the listening position. So, a setting of 20 milliseconds would be
equivalent to increasing this distance by approximately 21.5
feet (6.6 meters). If you are using a surround-sound receiver
or amplifier equipped with an automatic calibration function,
its LFE output signal will automatically set the delay time
internally so delay on the Deep
TM
subwoofer should be set to
minimum.
AUTO EQ
Your Deep
TM
subwoofer is equipped with an easy-to-use and
highly sophisticated automatic calibration function. This
activates the Deep
TM
subwoofer via the APP and instructing it to
play a measurement signal and uses the built-in microphone
in your smartphone to show the measurement curve, within
the range. Automatic room calibration is performed in two
steps.
Step 1
calibrates the measurement environment,
which includes the microphone and the sound reproduction
chain.
Step 2
measures the actual room frequency response.
Follow the instructions
in the APP to carry out a successful
measurement. The Auto EQ measurement begins with you
being asked to hold the smartphone close to the sound
opening of the Deep
TM
subwoofer. The measurement can then
be started.
Once the calibration step is completed, the actual room
measurement can be performed. Do this by holding your
smartphone at the listening position and start step 2.
After a successful measurement, the app provides visual
parameters of the measured room along with the automatically
calculated filter recommendations and saves them to your
subwoofer.
Press
“Redo”
to start another measurement from
Step 1
.
The equalization curve is retained until it is overwritten by
a new measurement. You can deactivate the automatically
calculated frequency response compensation at any time by
switching off the
AUTO EQ
function in the
SETUP
menu.
REDO
SAVED !
