6
Seasons Outdoor Collection™ Manual
Lay out the speakers and subwoofer in their selected locations. To prevent water
damage, angle the speaker less than 45 degrees up.
Dig a hole for the subwoofer, about 16” deep and 11” in diameter. Use loose dirt
to level the subwoofer. The subwoofer shouldn’t be in contact with large rocks or
large empty holes.
Dig a 5” trench where you plan on laying out the wire. Run the wire from the
amplifier to your first speaker location.
1. Installing the System
You will need a wire that has at least two conductors; one that can be identified
as the positive and the other as the negative. All two conductor wires have some
means of identifying which conductor is which, but at times this identification
may be subtle. It’s crucial that you keep track of which wire you use for positive
(+) and negative (-). Typically if the wires are colored red and black, the red wire
is used for positive and the black wire is used for negative, but sometimes other
colors or patterns are used. You can choose whichever color of wire you want to
be positive and negative as long as you remain consistent throughout the install.
On both your amplifier and your speaker the connectors will be identified as red
for positive and black for negative. It is very important to look carefully at the
speaker wires and be certain that the same wire that is attached to the positive
connector in the amplifier is attached to the positive connector in the speaker.
About Speaker Wire
