3. 2
Mounting the capacitor (For only single-phase motors)
Before mounting the provided capacitor,check that the capacitor’s capacitance matches that stated on the motor’s name plate .
Use the screws specified below to install capacitor. (screws not provided).
※
Dimensions in millimeters (inches).
Note
-When installing the capacitor with the plastic foot, tighten the screw to a torque of 1 N·m (10 kgfcm) or less to prevent damage to
the mounting foot.
-Mount capacitor at least 10 cm (3.94inches) away from the motor. If it is located closer, the life of the capacitor will be shortened.
3. 3
Changing Direction of the Cable Outlet
In case of 60W and 90W type,the direction of the cable outlet is the output shaft side of the motor when shipping.
The direction of outlet can be changed by 180
ﾟ
if desired.
Change the direction of the cable outlet according to following steps.
q
Remove screws and upper unit of cable clamp.
Put the cable toward the opposite direction.
w
Turn the cable clamp to change the direction of cable outlet.
e
Refasten upper unit of cable clamp with screws.
Note:
Keep the tightening torque within the limits shown below to prevent
the cable from coming loose or to damage caused by excessive
tightening torque.
Screw tightening torque
0.5 N·m (5 kgfcm) ~ 0.7 N·m (7 kgfcm)
3
M3 hexagonal
socket-head screw
Cable clamp
Cable
q
w
e
5-
φ
4.5
φ
4.3
(.169DIA.)
(.177DIA.)
Mounting feet equipped.
Use screws of 4 mm in diameter to install the capacitor.
