Oriental motor BX2 Driver Edition Series, Руководство по эксплуатации

Страница: 19 / 28

19
Operation
7 Operation
Four control modes are provided in the BX Ⅱ Series.
This chapter explains two operating methods that the motor can be operated immediately in the speed control mode
(factory setting).
• Operation by input signals
• Test operation (JOG operation)
Refer to the USER MANUAL for other control modes and how to use in details.
7.1 Operation by input signals
The motor can be operated by inputting signals to control operation.
1. Connect the input signals shown in the figure.
Signals required for operation are assigned to the input terminals of CN5 in advance.
Check the following table.
CN5
Pin No.
Signal name Function Description
Pin No.2 FWD
Pin No.8 STOP
Pin No.11 IN-COM1
CN5
Pin No.3 RVS
2 IN0 FWD
This signal is used to rotate the motor in
the clockwise direction.
3 IN1 RVS
This signal is used to rotate the motor in
the counterclockwise direction.
8 IN6 STOP
This signal is used to stop the motor
instantaneously.
11 IN-COM1 Input signals common 0 V (for built-in power supply)
2. Turn SW1-4 ON.
SW1-4
SW1-1
SW1-2
3. Set the operating speed of the motor.
Refer to “Setting the operating speed” for how to set.
4. Operate the motor.
When FWD is turned ON, the motor rotates in the clockwise direction.
When RVS is turned ON, the motor rotates in the counterclockwise direction.
5. Stop the motor.
When the operating signal having turned ON is turned OFF, the motor decelerates to a stop.
If STOP is turned ON, the motor stops instantaneously.
If both FWD and RVS are turned ON, the motor decelerates to a stop.
ON
OFF
ON
OFF
ON
OFF
STOP
RVS
FWD
Motor operation
Deceleration
stop
Deceleration
stop
Instantaneous
stop
Electromagnetic
brake ∗
Release Release Release
∗ In the case of electromagnetic brake type