Oriental motor BX2 Driver Edition Series, Руководство по эксплуатации

Страница: 16 / 28

16
Connection
6.5 Connecting the motor (CN2, CN3, CN4)
Connect the motor to the driver via the dedicated connection cable (sold separately).
Connect the motor power connector of the connection cable to CN2, the electromagnetic brake connector to CN3, and
the encoder connector to CN4.
When extending the wiring distance between the motor and the driver, use the connection cable (for extension) which
is sold separately.
The wiring distance can be extended to a maximum of 30.3 m (99.4 ft.).
Driver
Motor
Connection cable
or flexible connection cable
Required
Connection cable (for extension)
or flexible connection cable (for extension)
Connect to CN4
Connect to CN3
Connect to CN2
Note
Be sure to use the dedicated connection cable (sold separately) to connect the motor.
6.6 Selecting a power supply for input signals
Select a power supply for input signals (use the built-in power supply or external power supply).
When controlling using a relay or a switch, turn SW1-4 ON to select the built-in power supply.
Factory setting: OFF (use an external power supply)
SW1-4
Note
The built-in power supply cannot be used in the case of source logic. Do not turn the switch ON.
6.7 Connecting the I/O signals (CN5, CN7)
Connect the input signals to CN5 and the analog
external input signals and output signals to CN7.
Applicable lead wire: AWG26 to 20 (0.14 to 0.5 mm
2
)
Lead wire strip length: 8 mm (0.31 in.)
8 mm
(0.31 in.)
Insert the lead wire while
pushing the button of the
orange color with a screwdriver.
Button of the orange color
Applicable crimp terminal
If crimp terminals are used, select the following terminals.
Manufacturer PHOENIX CONTACT GmbH & Co. KG
Model
A 0,25-7 [AWG24 (0.2 mm
2
)]
A 0,34-7 [AWG22 (0.3 mm
2
)]
A 0,5-8 [AWG20 (0.5 mm
2
)]
„ „
CN5 pin assignments
Pin No. Signal name Function ∗
1 IN-COM0 Input signals common (for external power supply)
1
2
3
8
9
10
11
4
5
6
7
Manufacturer: PHOENIX CONTACT GmbH & Co. KG
Model: FK-MC0,5/11-ST-2,5
2 IN0 Input terminal 0 [FWD]
3 IN1 Input terminal 1 [RVS]
4 IN2 Input terminal 2 [M0]
5 IN3 Input terminal 3 [M1]
6 IN4 Input terminal 4 [M2]
7 IN5 Input terminal 5 [FREE]
8 IN6 Input terminal 6 [STOP]
9 IN7 Input terminal 7 [ALM-RST]
10 IN8 Input terminal 8 [Not used (possible to assign)]
11 IN-COM1 0 V (for built-in power supply)
∗ The signal in brackets [ ] is a function that is assigned at the time of shipment (speed control mode).