Oridion Capnostream 20p, Руководство оператора

Страница: 32 / 141

Turning on the Monitor
30 Portable Bedside Capnograph/Pulse Oximeter
Monitor Left and Right Views
The left side of the monitor contains the battery housing and the connection points to the patient interface.
Figure 8 - Capnostream Left View
Table 6 describes the functions of the features on the left side of the monitor.
Table 6 - Capnostream Left View
Label Function Description
1 FilterLine Input connector To connect the FilterLine to the monitor. Provided
with an automatic door close.
2 Gas outlet To connect to a scavenger system when the
monitor is used in the presence of anesthetic
gases. The gas output is a barbed style connector
intended for 3/32 inch ID tubing.
3 SpO
2
To connect SpO
2
sensor to the monitor with an
extension cable.
4 Battery housing Where the battery pack is installed.
5 Barcode label Barcode of the Serial Number and Model Number
of monitor.
The right side of the monitor includes only the paper roll used for printing patient reports and buttons used to
control that printer. This printer roll holder is seen in
Figure 45 - Insert Paper Roll into printer on page 115 , and
instructions for replacing the printer roll appear in Replacing the Printer Paper Roll on page 115 .
Turning on the Monitor
This section explains how to turn on the monitor.
CAUTION: The monitor is intended only as an adjunct in patient assessment. It must be used in
conjunction with clinical signs and symptoms.
CAUTION: Use only Microstream
®
etCO
2
consumables and Nellcor sensors, to ensure that the monitor
functions properly.
1
2
3
4
5