3
3 Installation
3.1
Installing batteries (supplied)
Three good quality AA batteries are required to allow the display to
function.
Before opening the battery compartment, make sure the telephone is
disconnected from the telephone line.
1.
On the underside of the telephone carefully remove the battery cover.
2.
Insert three AA batteries ensuring correct battery polarity is
observed.
3.
Replace the battery cover.
When the batteries are running low
will be displayed.
Warning: When replacing the batteries you must install 3 new AA
batteries within 1 minute of removing the old batteries, or you risk losing
your stored memories.
3.2
Connecting the telephone
1.
Plug one end of the curly cord into the socket on the handset.
2.
Plug the other end of the curly cord into the socket at the end of the
base. Thread the curly cord through the groove toward the back of
the base.
3.
Plug the telephone cable supplied into the socket on the bottom of
the base.
4.
Plug the other end of the telephone cable into the wall socket. Thread
the curly cord through the groove toward the back of the base.
3.3
Hanging the Phone on the Wall
Slide out the handset guide on the base, rotate it 180° and replace it.
The handset will rest on the guide when wall mounted.
On existing wall phone plate
1.
Attach the wall mount bracket (supplied) to the base.
2.
Hang the base on to the two pins on wall phone plate and pull the
base down to lock it on.
Without wall phone plate
1.
Drill two holes vertically, one above the other, 100mm apart, and
leave the screws protruding from the wall by 5mm.
2.
Hang the base on to the two screws and pull the base down to lock
it on.
