Oricom secure 910, Руководство пользователя

Страница: 7 / 24

6 GETTING STARTEd GETTING STARTEd
1. Camera Setup
1.1 Power supply
a) Connect the small plug of the power adaptor to the baby unit and the other
end to the electrical mains power outlet.
b) To switch on the baby unit, slide the power switch to the ON position. The
power LED will light up.
c) To switch off the baby unit, slide the power switch to the OFF position.
1.2 Batteries
In case of power failure the baby unit can be fitted with 4 x AAA alkaline bat-
teries (not supplied).
To install the batteries use a small screwdriver to open the battery compart-
ment on the rear of the camera unit. Leaving the ribbon under the batteries,
insert the batteries observing the correct polarity indicated in the battery com-
partment. The ribbon is used for easy removal of batteries.Close the battery
compartment again and secure the screw in place.
Please check and replace these batteries after each power failure or every 12
months.
1.3 Connecting and aligning the baby unit
Position the baby unit with a minimum distance of 1 metre to other electronic
devices to avoid a risk of mutual disturbance. Point the upper section of the
baby unit towards the baby you wish to monitor. The baby unit should be at
least 1 metre away from the baby. Check that the baby is suitably displayed on
the parent unit screen. Adjust the viewing angle by gently rotating the camera
head until the baby is clearly visible.
Use only the AC adaptor supplied with the product as other power adaptors could
damage the product. This product is designed for indoor use only.