•
#7
Speed control. Let it Off if you don't have installed any sensor on your crank. If you
set ON, when you'll press the “PLAY” button, Midilector will wait for the
impulsions from the crank sensor. The tempo will follow the speed of the crank. The
song will stop if you stop cranking. In you set “PA”, the song will start when you
turn and stop when you stop turning but wont follow the speed of crank.
•
#8
Signal frequency from the crank sensor in BPM. Set here your “normal” speed. If
you turn faster, the tempo will increase, if you slow down, tempo will decrease. Let
it as it is if you don't use synchronisation.
•
#9
That's the minimum speed under which the song stops. Let it if you don't use
synchronisation
•
#10
Numbers of pulsations from the crank sensor before starting. Needed for fulling the
reservoir. Let it if you don't use the synchronisation.
Leave the menu by « STOP ». Midilector has got a good memory, it will remember
your set-up even after a night sleeping !
Back light
The screen is normally back-lit. To save your battery, you can install a switch to
switch off it when it is useless, outside for example. Just connect 2 threads from the
switch to the marked " back light " pins on the board
